One of the most basic and important facts an installer should know when working with ceramic including porcelain glass and natural stone tile is to always have expansion joints in place.
Ceramic tile over expansion joints.
If expansion joints are not part of the installation failure is lurking in the shadows waiting to strike.
Recognizing that tile is a facade movement joints are needed to eliminate stresses that can occur between the substrate and the tile due to differing amounts of expansion and contraction.
An expansion joint is in the substrate for instance in concrete.
If you tile over an expansion joint then you need to honor that joint in the tile as well.
A movement joint is in the tile only.
Expansion joint locate ctc joint in tile or stone surfaces directly above joints in sub floor full length may be fastened to sub floor using a construction adhesive trowel setting material making sure there is full coverage over the entire leg to ensure a smooth transition mortar bed may be.
1 8 movement with any sheet system typically and 1 16 with a few trowel on systems.
For installation of tile the tile ends at each control joint and the gap if filled with caulk rather than grout.
It allows for movement in the tile.
The tcna handbook recommends allowing for expansion and contraction in every tile installation.
It s quite common to see controlled breaks in concrete and those are usually expansion joints.
Control joints are there because it s not a question of if the slab will crack but rather when the slab cracks it hopefully happens at the joint.
Control joints may be relocated.
However depending on the tile size and system up to 1 4 movement is possible on the horizontal.
Where should movement joints be placed.